<strong id="mxjka"><del id="mxjka"></del></strong>
      <ol id="mxjka"><blockquote id="mxjka"></blockquote></ol>
      <legend id="mxjka"><li id="mxjka"></li></legend>
      1. <strong id="mxjka"></strong><track id="mxjka"></track>

        <strong id="mxjka"></strong>
        <acronym id="mxjka"></acronym>



        型號 封裝 在線定購
        LPC1343FBD48(查看) LQFP48
        LPC1343FHN33(查看) HVQFN33


        技術資料—— LPC1343 PDF技術資料
        LPC1343 參數
        LPC1343 存儲器
        Flash (KB) 32
        RAM (kB) 8
        LPC1343 其他參數
        fmax (MHz) 72
        I/Opins 28-42
        UART 1
        I2C 1
        I2S -
        SPI 1
        SSP 1
        ADC 8
        DAC -
        定時器 5
        PWM 11
        I/O 電壓 (V) 3.3
        CPU 電壓 (V) 3.3
        LPC1343 封裝與引腳

        LPC1343 概述

        The LPC1343 are ARM Cortex-M3 based microcontrollers for embedded applications featuring a high level of integration and low power consumption. The ARM Cortex-M3 is a next generation core that offers system enhancements such as enhanced debug features and a higher level of support block integration.

        The LPC1343 operate at CPU frequencies of up to 72 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching.

        LPC1343 特性

        • 10-bit ADC with input multiplexing among 8 pins
        • ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)
        • ARM Cortex-M3 processor, running at frequencies of up to 72 MHz
        • 32 kB on-chip flash programming memory.
        • 8 kB SRAM.
        • Code Read Protection (CRP) with different security levels
        • GPIO pins can be used as edge and level sensitive interrupt sources
        • High-current output driver (20 mA) on one pin
        • High-current sink drivers (20 mA) on two I2C-bus pins in Fast-mode Plus
        • In-Application Programming (IAP)
        • In-System Programming (ISP)
        • Integrated oscillator with an operating range of 1 MHz to 25 MHz
        • Power-On Reset (POR)
        • Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz
        • Serial Wire Debug and Serial Wire Trace port
        • Single power supply (2.0 V to 3.6 V)
        • Three reduced power modes: Sleep, Deep-sleep, and Deep power-down
        • Unique device serial number for identification
        • USB 2.0 full-speed device controller