<strong id="mxjka"><del id="mxjka"></del></strong>
      <ol id="mxjka"><blockquote id="mxjka"></blockquote></ol>
      <legend id="mxjka"><li id="mxjka"></li></legend>
      1. <strong id="mxjka"></strong><track id="mxjka"></track>

        <strong id="mxjka"></strong>
        <acronym id="mxjka"></acronym>

        LPC1311

        芯片信息

        型號 封裝 在線定購
        LPC1311FHN33(查看) HVQFN33

        引腳布局

        (點擊圖片看大圖)
        技術資料—— LPC1311 PDF技術資料
        LPC1311 參數
        LPC1311 存儲器
        Flash (KB) 8
        RAM (kB) 4
        LPC1311 其他參數
        fmax (MHz) 72
        I/Opins 28
        UART 1
        I2C 1
        I2S -
        SPI 1
        SSP 1
        ADC 8
        DAC -
        定時器 5
        PWM 11
        I/O 電壓 (V) 3.3
        CPU 電壓 (V) 3.3
        LPC1311 封裝與引腳
        HVQFN33

        LPC1311 概述

        The LPC1311 are ARM Cortex-M3 based microcontrollers for embedded applications featuring a high level of integration and low power consumption. The ARM Cortex-M3 is a next generation core that offers system enhancements such as enhanced debug features and a higher level of support block integration.

        The LPC1311 operate at CPU frequencies of up to 72 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching.

        LPC1311 特性

        • ARM Cortex-M3 processor, running at frequencies of up to 72 MHz.
        • ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC).
        • 8 kB on-chip flash programming memory.
        • 4 kB SRAM.
        • In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software.
        • Serial Wire Debug and Serial Wire Trace port
        • High-current output driver (20 mA) on one pin
        • High-current sink drivers (20 mA) on two I2C-bus pins in Fast-mode Plus
        • Three reduced power modes: Sleep, Deep-sleep, and Deep power-down
        • Single power supply (2.0 V to 3.6 V).
        • 10-bit ADC with input multiplexing among 8 pins
        • Integrated oscillator with an operating range of 1 MHz to 25 MHz.
        • Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz.
        • Serial interfaces:
          • UART with fractional baud rate generation, modem, internal FIFO, and RS-485/EIA-485 support.
          • SSP controller with FIFO and multi-protocol capabilities
          • I2C-bus interface supporting full I2C-bus specification and Fast-mode Plus with a data rate of 1 Mbit/s with multiple address recognition and monitor mode
        • Other peripherals:
          • Up to 28 General Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors.
          • Four general purpose counter/timers with a total of four capture inputs and 13 match outputs.
          • Programmable WatchDog Timer (WDT).
          • System tick timer.



        撸撸资源